Original Research

Assessing airborne microplastics in urban indoor environments using PM2.5 air exchange rate and polymer characterization for respiratory health risk evaluation

Abstract

Introduction: Airborne microplastics have recently emerged as indoor air pollutants in urban environments due to extensive use of synthetic textiles, furnishings, and plastic-based materials. Continuous inhalation exposure may pose respiratory health risks, particularly in densely occupied spaces with poor ventilation. This study quantifies airborne microplastic concentrations in urban indoor environments and evaluates mitigation strategies based on ventilation improvement and material management.
Materials and methods: Air sampling was conducted in residential rooms, classrooms, and office spaces using low-volume active air samplers fitted with quartz microfiber filters (flow rate 16.7 L/min; duration 8 h). Microplastics were identified and counted using optical microscopy, while polymer types were confirmed through Fourier Transform Infra-Red (FTIR) spectroscopy and Scanning Electron Microscopy (SEM) analysis. Environmental parameters including PM2.5 concentration, Air Exchange Rate (AER), relative humidity, temperature, and occupancy density were simultaneously recorded. Respiratory exposure risk was estimated using inhalation dose and Hazard Quotient (HQ) calculations.
Results: Microplastics were detected in all indoor environments, with mean concentrations of 600 particles/m3 in residences, 1050 in offices, and 1180 in classrooms. Fibers dominated (68%), mainly polyester and polypropylene. Higher concentrations were associated with low ventilation (AER 0.4 h−1), high occupancy density (0.85 persons/m2), and elevated PM2.5
levels (>45 µg/m3). Estimated inhalation exposure ranged from 2.1 to 3.8 particles/kg/day, and HQ exceeded the safe threshold (1.32) in poorly ventilated classrooms. Increasing AER to 1.2 h−1 reduced concentrations by 39%, replacing synthetic textiles lowered fiber proportion to 41%, and reducing occupancy to 0.55 persons/m2 decreased inhalation dose to 2.1 particles/kg/day and HQ to 0.78.
Conclusion: Airborne microplastics are prevalent in indoor environments and may contribute to respiratory health risks, especially under low ventilation and occupancy. Enhancing ventilation, indoor materials, and occupancy reduce concentrations and risks, underscoring importance of indoor air management strategies.

1. Prata JC, da Costa JP, Lopes I, Duarte AC, Rocha-Santos T. Environmental exposure to microplastics An overview on possible human health effects. J Science of The Total Environment. 2020;702:134455.
2. Dris R, Gasperi J, Mirande C, Mandin C, Guerrouache M, Langlois V, Tassin B. A first overview of textile fibers including microplastics in indoor and outdoor environments. J Environmental Pollution. 2017;221:453-8.
3. Vianello A, Jensen RL, Liu L, Vollertsen J. Simulating human exposure to indoor airborne microplastics using a breathing thermal manikin. J Scientific Reports. 2019;9:8670.
4. Zhang Q, Zhao Y, Du F, Cai H, Wang G, Shi H. Microplastic fallout in different indoor environments. J Environmental Science and Technology. 2020;54(11):6530-9.
5. Abbasi S, Turner A. Human exposure to microplastics through indoor dust ingestion A review. J Environment International. 2021;156:106734.
6. Chen Q, Li Y, Li B, Chen G. Microplastics in indoor environments Sources analytical methods and implications. J Hazardous Materials. 2020;389:121846.
7. Amato-Lourenco LF, Carvalho-Oliveira R, Junior GR, Galvao LS, Ando RA, Mauad T. Presence of airborne microplastics in human lung tissue. J Environment International. 2021;153:106499.
8. Catarino AI, Thompson R, Sanderson W, Henry TB. Development and optimization of a standard method for extraction of microplastics in indoor air. J Analytical Methods. 2018;10:3754-63.
9. Liu K, Wang X, Fang T, Xu P, Zhu L, Li D. Source and potential risk assessment of suspended atmospheric microplastics in Shanghai. J Atmospheric Environment. 2019;209:124-32.
10. Gasperi J, Wright SL, Dris R, Collard F, Mandin C, Guerrouache M, Langlois V, Kelly FJ, Tassin B. Microplastics in air Are we breathing it in. J Current Opinion in Environmental Science and Health. 2018;1:1-5.
11. Liao Z, Ji X, Ma Y, Lv B, Huang W, Zhu X, Fang M, Wang Q, Wang S. Airborne microplastics in indoor and outdoor environments of a coastal city in China. J Marine Pollution Bulletin. 2021;165:112115.
12. Wang X, He Y, Yuan Y, Chen Y, Huang Q, Wang H. Microplastics in urban indoor environments Characteristics and health risk assessment. J Building and Environment. 2020;181:107120.
13. Rahman A, Sarkar A, Yadav OP, Achari G, Slobodnik J. Potential human health risks due to environmental exposure to nano and microplastics and knowledge gaps. J Science of The Total Environment. 2021;757:143872.
14. Cox KD, Covernton GA, Davies HL, Dower JF, Juanes F, Dudas SE. Human consumption of microplastics. J Environmental Science and Technology. 2019;53(12):7068-74.
15. Wright SL, Kelly FJ. Plastic and human health A micro issue. J Environmental Science and Technology. 2017;51(12):6634-47.
16. Pauly JL, Stegmeier SJ, Allaart HA, Cheney RT, Zhang PJ, Mayer AG, Streck RJ. Inhaled cellulosic and plastic fibers found in human lung tissue. J Cancer Epidemiology Biomarkers and Prevention. 1998;7(5):419-28.
17. Allen S, Allen D, Phoenix VR, Le Roux G, Jimenez PD, Simonneau A, Binet S, Galop D. Atmospheric transport and deposition of microplastics in a remote mountain catchment. J Nature Geoscience. 2019;12:339-44.
18. Hernandez LM, Xu EG, Larsson HCE, Tahara R, Maisuria VB, Tufenkji N. Plastic teabags release billions of microparticles and nanoparticles into tea. J Environmental Science and Technology. 2019;53(21):12300-10.
19. Li L, Luo Y, Li R, Zhou Q, Peijnenburg WJGM, Yin N, Yang J, Tu C, Zhang Y. Effective uptake of submicrometre plastics by crop plants via a crack entry mode. J Nature Sustainability. 2020;3:929-37.
20. Yang L, Li K, Cui S, Kang Y, An L, Lei K. Removal of microplastics in municipal wastewater treatment plants A review. J Water Research. 2021;191:116807.
21. Zhang Y, Kang S, Allen S, Allen D, Gao T, Sillanpaa M. Atmospheric microplastics A review on current status and perspectives. J Earth Science Reviews. 2020;203:103118.
22. Kannan K, Vimalkumar K. A review of human exposure to microplastics and insights into microplastics as obesogens. J Frontiers in Endocrinology. 2021;12:724989.
23. Wright SL, Ulke J, Font A, Chan KLA, Kelly FJ. Atmospheric microplastic deposition in an urban environment and an evaluation of transport. J Environment International. 2020;136:105411.
24. Soltani NS, Taylor MP, Wilson SP. Quantification and exposure assessment of microplastics in indoor dust from urban homes. J Environmental Research. 2021;193:110531.
25. Liu C, Li J, Zhang Y, Wang L, Deng J, Gao Y, Yu L, Zhang J, Sun H. Widespread distribution of microplastics in the atmospheric fallout of a megacity. J Environmental Science and Technology Letters. 2019;6(7).
Files
IssueVol 11 No 2 (2026): Spring 2026 QRcode
SectionOriginal Research
Keywords
Microplastics; Polymer; Fourier transform infrared spectroscopy (FTIR); Scanning electron microscopy (SEM); Sampling; Ventilation; Particulate matter (PM2.5 )
Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
1.
Sivalingam S, Sivasamy N, Loganathan M, Rajendran A, Ravikumar S, Narayanan V. Assessing airborne microplastics in urban indoor environments using PM2.5 air exchange rate and polymer characterization for respiratory health risk evaluation. JAPH. 2026;11(2):201-216.